How to cook rice on the stove and get it right every time
A pot of rice is a small exercise in steam management, and most failures come from lifting the lid, guessing the water, or skipping the ten minutes of rest at the end.
Rice has two ingredients and somehow three ways to fail. It comes out as a sticky mass, or with a chalky centre, or with a brown crust welded to the bottom of the pot, and occasionally it manages two of those in the same batch. People who cook complicated things with confidence still approach a pan of plain rice with suspicion.
The method most kitchens use is absorption: a measured amount of water, a lid, and low heat until the water is gone. The rice at the bottom simmers, the rice at the top steams, and the whole thing only works if the steam stays in the pot. Once that is understood, the rules stop feeling like superstition.
Rinse, then measure
Dry rice is coated in loose starch from milling and transport. In the pot, that powder dissolves into the water and turns it into glue. Put the rice in a bowl, cover it with cold water, swirl with your hand, and pour the cloudy water off. Repeat until the water is merely hazy, usually three or four changes, then drain well so you are not adding unmeasured water.
The exceptions are dishes that rely on that starch. Risotto rice and rice for puddings should go in unwashed, because the creaminess comes from exactly the starch you would be rinsing away.
Measure by volume with the same cup for rice and water, and the ratio holds whatever the cup is. The figures below are sensible starting points for a pot with a well-fitting lid. Packets vary, and so do stoves, so adjust by a few spoonfuls once you have seen how your own setup behaves.
| Long-grain white, including basmati and jasmine | 1 to about 1.5, simmered 12 to 15 minutes |
|---|---|
| Medium and short-grain white | 1 to about 1.25, simmered 12 to 15 minutes |
| Brown rice | 1 to about 2, simmered 35 to 45 minutes |
| Any of the above | Plus 10 minutes resting off the heat, lid on |
One thing catches people when they scale up. The water that evaporates during cooking depends on the pot and the time, not on the amount of rice, so doubling the rice does not quite mean doubling the water. For a large batch, hold back a little. For a very small one, add a little extra, or use a smaller pot.
The method, step by step
- Put the rinsed, drained rice in a heavy-based pot with the measured water and a good pinch of salt.
- Bring it to a boil with the lid off, and give it one stir to free any grains stuck to the bottom.
- Turn the heat to the lowest setting your burner will hold, put the lid on, and start a timer.
- Do not lift the lid. Every look lets out steam the top layer of rice needs, and drops the temperature in the pot.
- When the time is up, take the pot off the heat and leave it covered for ten minutes.
- Fluff with a fork or a flat paddle, lifting from the bottom and turning, not stirring in circles.
The rest is the step that gets skipped and the one that matters most. Straight off the heat, the bottom of the pot is wetter than the top and the grains are fragile. Ten minutes lets the moisture even out and the surface of each grain firm up, which is the difference between rice that separates and rice that smears.
When it goes wrong
- Mushy and wet: too much water, or the rice was not drained after rinsing. Next time reduce the water by a few spoonfuls. For now, spread it on a tray to steam dry for a few minutes, or keep it for fried rice.
- Hard in the middle: too little water, a loose lid, or too much peeking. Sprinkle over a few spoonfuls of hot water, cover, and give it five more minutes on the lowest heat.
- Scorched underneath: the heat was too high or the pot too thin. Do not scrape. Lift the good rice off the top and leave the crust behind, since stirring it in spreads the burnt taste through everything.
- Boiling over: the pot is too small. Rice needs room, roughly three times the depth of the dry grain and water together.
- Cooked but bland: salt the water. Rice seasoned afterwards never tastes the same as rice seasoned as it cooks.
If your burner cannot go low enough, a heat diffuser under the pot helps. So does moving the covered pot into a moderate oven for the simmering stage, which heats it gently from all sides and makes scorching very hard to achieve.
Small upgrades once the basics work
Soaking basmati in cold water for twenty to thirty minutes before cooking gives longer, more separate grains, and shortens the cooking time by a few minutes. Drain it well and use slightly less water, since the grains have already taken some in.
Toasting the dry rice in a little butter or oil for a minute or two before adding the water gives a nuttier flavour and helps the grains stay distinct. This is the basis of a pilaf: soften some onion in the fat first, add whole spices or a bay leaf, and use stock in place of water.
Leftover rice needs prompt handling
Cooked rice should not sit around at room temperature. Spores of a bacterium commonly found on rice can survive cooking and, if the rice is left warm for hours, produce a toxin that reheating does not destroy. The conservative practice is simple: cool leftovers quickly by spreading them out in a shallow container, get them into the fridge within an hour or so, eat them within a day or two, and reheat until steaming hot all the way through, once only.
Handled like that, yesterday's rice is an asset. Cold, slightly dried grains are precisely what fried rice needs, because fresh rice carries too much surface moisture and turns to porridge in the pan.